Walker Caneholder – Assembly Instructions

Walker Caneholder – Assembly Instructions

Turn the upper holder so that the logotype is facing upwards. 1 Turn the upper holder so that the logotype is facing upwards.

Note: The logo facing upwards

Snap the holder onto the upper part of the hand grip tube. 2 Snap the holder onto the upper part of the hand grip tube.

Snap the holder onto the upper part of the hand grip tube and then screw it in place with a Phillips screwdriver.

If you attach the both Cane Holder and the Backrest 3 If you attach the both Cane Holder and the Backrest

Note: Adjust the position of the brake lever so that there is room for the upper cane holder next to the backrest. It might be necessary to tilt the cane holder outwards, approximately 30 degrees, to fit the cane holder and the backrest on the Walker.

Attach the lower holder to the frame 4 Attach the lower holder to the frame

For right-/left-hand side assembly, turn the lower holder so you can reach the screw from the outside of the frame. To attach the lower holder to the frame, wrap the strap around the frame tube and push it into the hole of the holder.

Trionic USA, INC. • 1545 N. Verdugo Rd. • Glendale, CA 91208 • USA • 818-480-1907 • info@trionic.us

Tighten the screw/strap 5 Tighten the screw/strap

Tighten the screw/strap by using a 4 mm Allen key.

Cut the excessive length of the strap 6 Cut the excessive length of the strap

Cut the excessive length of the strap with a cable cutter.

Ready for use 7 Ready for use

P7 Text

Trionic USA, INC. • 1545 N. Verdugo Rd. • Glendale, CA 91208 • USA • 818-480-1907 • info@trionic.us